Table of Contents
Advertisement
Bench Mounting
Number of Mounting Holes ............................ 4
Dia. of Mounting Hardware Needed ..........
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Figure 8. Typical "Through Mount" setup.
Another option is a "direct mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Machine Base
Workbench
Figure 9. Typical "Direct Mount" setup.
Model G0893 (Mfd. Since 03/19)
⁄
"
5
16
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Lag Screw
Flat Washer
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
1.
Use (2) M8-1.25 x 20 cap screws, (2) 8mm flat
washers, and (2) 8mm lock washers to attach
carriage support to jointer (see Figure 10).
x 2
Figure 10. Attaching carriage support to bed
assembly.
2.
Insert locking plate assembly into carriage
support, so locking plate pins are against
bottom edge of carriage support (see Figure
11). Then attach fence carriage lock lever
and 10 x 3.5mm beveled washer to locking
plate assembly, as shown in Figure 12 on
Page 18).
Locking Plate
Assembly
Figure 11. Inserting locking plate assembly.
Cap Screws
Carriage Support
Locking
Plate Pins
-17-
Advertisement
Table of Contents
