Table of Contents
Advertisement
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
A
C
D
G
H
K
Figure 7. Box 1 inventory contents.
M
Figure 8. Box 2 inventory contents.
-16-
B
F
E
J
I
L
N
O
Wood Crate (Figure 7)
A. Jointer Assembly ........................................ 1
B. Fence Assembly, Carriage, &
Carriage Mount .....................................1 Ea.
C. Handwheels ................................................ 2
D. Push Blocks ................................................ 2
E. Dust Port .................................................... 1
F.
Knife-Setting Jig ......................................... 1
G. Handles ...................................................... 2
H. Open-End Wrenches 8/10, 11/13mm ....1 Ea.
I.
Belt ............................................................. 1
J.
Cutterhead Guard ....................................... 1
K. Hex Wrenches 3, 4, 5, 6mm .................1 Ea.
L. Fence Tilt Lever .......................................... 1
Cardboard Box (Figure 8)
M. Stand Assembly w/Motor and Door ........... 1
N. Pedestal Switch Assembly ......................... 1
O. Foot Pedal Caster Assembly ...................... 1
Fasteners & Tools (Not Shown) ................. Qty
•
Cap Screws M8-1.25 x 40 (Jointer/Stand) .. 4
•
Lock Washers 8mm (Jointer/Stand) ........... 4
•
Flat Washers 8mm (Jointer/Stand) ............. 4
•
Cap Screws M8-1.25 x 45
(Carriage Mount) ........................................ 4
•
Lock Washers 8mm (Carriage Mount) ....... 4
•
Cap Screws M8-1.25 x 50 (Wheel/Stand) .. 3
•
Lock Washers 8mm (Wheel/Stand) ........... 3
•
Flat Washers 8mm (Wheel/Stand) ............. 6
•
Hex Nuts M8-1.25 (Wheel/Stand) ............... 3
•
Phillips Head Screws M5-.8 x 10
(Dust Port) .................................................. 4
•
Flat Washers 5mm (Dust Port) ................... 4
•
Key 5 x 5 x 20 (Handwheels) ..................... 2
G0656XW Only:
•
Indexable Carbide Inserts .......................... 5
•
Insert Screws .............................................. 5
•
T-Handle Torx Driver T20 ........................... 2
Model G0656W/G0656XW (Mfd. Since 08/16)
Qty
Qty
Advertisement
Table of Contents
