Assembly - Grizzly G0813 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
The Model G0813 jointer stand must be assem-
bled. The Model G0814/G0814X stand requires
no assembly. Therefore, if assembling the Model
G0813, start at Step 1. If assembling the Model
G0814/G0814X, start at Step 18 on Page 27.
To assemble jointer:
1. Place top plate upside down on level surface,
then attach left and right chute supports to
top plate with (4) #10-24 x
and #10-24 hex nuts, as shown in Figure 15.
Ensure flanges face outward.
Left
Support
Top Plate
x 4
Figure 15. Dust chute supports attached to top
plate.
-24-
⁄ " flange screws
3
8
Flange
Right Support
2. Hold motor mount plate level, attach it to top
of chute supports with (2) #10-24 x
screws, then pivot plate down and install
(4) #10-24 x ⁄ " additional flange screws
3
8
(see Figure 16).
Note: Flange screws must be installed from
inside of chute supports.
x 6
Chute
Support
Figure 16. Motor mount plate attached to chute
supports.
3. Attach motor to base so pulley is aligned with
belt slot in top plate using (4)
carriage bolts, (4)
⁄ "-18 hex nuts (see Figure 17).
5
16
Note: Do not tighten any fasteners until
further instructed.
Pulley
Belt Slot
Figure 17. Motor attached to dust chute base.
Model G0813/G0814/G0814X (Mfd. Since 10/19)
⁄ " flange
3
8
Motor
Mount
Plate
⁄ "-18 x
5
16
⁄ " flat washers, and (4)
5
16
x 4
Dust Chute
Base
⁄ "
5
8