Test Run; Recommended Adjustments; Tighten Belt - Grizzly G0656XW Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1.
Clear all setup tools away from machine.
2.
Connect machine to power supply.
3. Turn machine ON, verify motor operation,
and then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
Congratulations! The Test Run is complete.
Proceed to Recommended Adjustments on the
this page.
-24-
Recommended
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate your machine.
However, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure the best
possible results from your new machine.
Step-by-step instructions for these adjustments
can be found in SECTION 7: SERVICE.
Factory adjustments that should be verified:
1. Knife Settings (Page 39).
2. Depth Scale Calibration (Page 42).
3. Fence Stop Accuracy (Page 43).
4. Table Parallelism (Page 46).

Tighten Belt

The final step in the setup process must be done
after approximately 16 hours of operation. During
this first 16 hours, the belt will stretch and seat
into the pulley groove. After this time, you must
re-tension the belt to avoid slippage and burn out.
Refer to Page 46 when you are ready to perform
this important adjustment.
Note: Pulleys and belt can get hot. This is a nor-
mal condition. Allow them to cool before making
adjustments.
A small amount of black belt dust at the bottom
of the belt housing is normal during the life of the
machine and does not indicate a problem with the
machine or belt.
Model G0656W/G0656XW (Mfd. Since 08/16)