Assembly And Commissioning; Scope Of Delivery; Transport - Grizzly G0875 Owner's Manual

3

Assembly and commissioning

INFORMATION
The CNC machine is delivered pre-assembled. It is delivered in a transport box.
3.1

Scope of delivery

Compare the scope of delivery with the attached packing list.
Check the status of the CNC machine immediately upon receipt and claim possible damages at
the last carrier also if the packing is not being damaged. In order to ensure claims towards the
freight carrier we recommend you to leave the machines, devices and packing material for the
time being in the status at which you have determined the damage or to take photos of this sta-
tus. Please inform us about any other claims within six days after receipt of delivery.
Check if all parts are firmly seated.
3.2

Transport

WARNING!
Severe or fatal injuries may occur if the machine or parts of the machine tumble or fall
down from the forklift truck or from the transport vehicle. Follow the instructions and
information on the transport box:
Centers of gravity

Load suspension points (Marking of the positions

for the load suspension gear)
Prescribed transportation position (Labelling of

the top surface)
Means of transport to be used

Weights

WARNING!
The use of damaged lifting and load suspension equipment without sufficient load
capacity that might break under load can cause severe injuries or even death.
Check that the lifting and load suspension equipment has sufficient load capacity and
that it is in perfect condition.
Observe the accident prevention regulations.
Fasten the loads carefully.
Never walk under suspended loads!
 Check the substructure. The substructure has to bear the load. (
substructure [kN/m2]" on page 3)
 Disassemble the lateral parts of the wooden box.
 The CNC-machine is lifted and transported with an appropriate handling device to the
installation place by means of a fork-lift truck.
-22-
 "Load capacity of the
Model G0875 (Mfd. Since 3/19)