Grizzly G0656XW Owner's Manual page 23

13. Install carriage with (2) pre-installed cap
screws and flat washers (see Figure 20).
14. Attach fence to carriage with (2) pre-installed
hex bolts and flat washers (see Figure 20).
Carriage
Figure 20. Carriage and fence installed.
15. Test guard by pulling it back and letting it
go. Guard should snap back quickly over
cutterhead.
— If guard does not snap back, or snaps
back slowly, remove guard and fence
assembly, repeat Steps 12–13, then re-
install fence.
Cutterhead guard must always return to
closed position whenever it is moved. If it
does not do this, it must be re-adjusted or
re-installed.
16. Install fence tilt lever (see Figure 21).
17. Loosen fence tilt lock (see Figure 21), tilt
fence to 90°, then tighten lock.
Fence Tilt
Lock
Figure 21. Fence tilt lever installed.
Model G0656W/G0656XW (Mfd. Since 08/16)
Fence
1 of 2
1 of 2
Fence Tilt
Lever
18. Loosen fence lock and rotate fence adjust-
ment knob to position fence flush with rabbet-
ing ledge, then tighten fence lock to secure
position (see Figure 22).
Fence
Lock
Fence
Adjustment
Knob
Figure 22. Fence positioned flush with rabbeting
ledge.
19. Check to make sure fence is parallel with rab-
beting ledge (see Figure 22).
— If fence is parallel with rabbeting ledge,
proceed to Step 20.
— If fence is not parallel with rabbeting
ledge, loosen cap screws shown in Figure
23, manually move fence until it is paral-
lel with rabbeting ledge, then tighten cap
screws to secure adjustment.
Figure 23. Location of cap screws for adjusting
fence parallelism.
Rabbeting
Ledge
-21-