Inventory - Grizzly G0960 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Track Inventory (Figure 10)
A. Track Rails .................................................. 4
B. Log Supports .............................................. 2
C. Adjustable Feet .......................................... 6
D. Log Bunks .................................................. 4
E. Rail Brackets .............................................. 2
F. Log Clamp Shafts ....................................... 2
G. Log Clamp Shaft Brackets ......................... 2
H. Log Clamps ................................................ 2
I. Log Clamp Receivers ................................. 2
Track Hardware (Not Shown)
J. Hex Bolts M12-1.75 x 35 ............................. 4
K. Hex Bolts M10-1.5 x 30 ............................ 48
L. Knob Bolts ⁄ "-18 x
5
16
M. Flat Washers ⁄ " ....................................... 48
3
8
N. Hex Nuts ⁄ "-12 ........................................ 12
1
2
O. Lock Nuts M12-1.75 .................................... 4
P. Flange Nuts M10-1.5 ................................ 48
Q. Spacers 12 x 17 x 15mm ............................ 4
Model G0960 (Mfd. Since 09/22)
Qty
Qty
⁄ " .............................. 5
5
8
A
C
D
F
E
H
I
Figure 10. Track inventory.
B
G
-15-