Table of Contents
Advertisement
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Jointer Inventory (Figures 5–6)
A. Jointer Bed Assembly................................. 1
B. Fence.......................................................... 1
C. Dust Collection Bag Clamp ........................ 1
D. Dust Chute ................................................. 1
E. Dust Collection Bag .................................... 1
F.
Push Blocks ................................................ 2
G. Handles ...................................................... 2
H. Fence Carriage Lock Lever ........................ 1
I.
Fence Tilt Lock Lever ................................. 1
J.
Replacement Inserts (5-Pack) .................... 1
K. Carriage Mounting Bracket ......................... 1
L. Carriage Assembly ..................................... 1
M. Fence Pivot Assembly ................................ 1
N. Limit Block .................................................. 1
O. Locking Pin Plate ........................................ 1
P.
Hex Wrenches 5, 6mm .........................1 Ea.
Q. T-Handle Torx Wrench T25 ........................ 2
R. Beveled Washers 10 x 3.5mm ................... 2
Fasteners (See Hardware Recognition Chart)
•
Cap Screws M6-1 x 20 ............................... 4
•
Cap Screws M8-1.25 x 30 .......................... 4
•
Cap Screws M8-1.25 x 20 .......................... 2
•
Flat Head Torx Screws M5-.8 x 10 ........... 10
•
Flat Washers 6mm ..................................... 4
•
Flat Washers 8mm ..................................... 2
•
Lock Washers 6mm.................................... 6
•
Lock Washers 8mm.................................... 2
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
-14-
Qty
Figure 5. Large components.
C
D
G
J
P
Figure 6. Small components.
A
B
E
I
H
K
M
Q
Model G0893 (Mfd. Since 03/19)
F
L
N
O
R
Advertisement
Table of Contents
