Table of Contents
Advertisement
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Loosen Inventory (Figure 4)
A. Front Extension Arms ................................. 2
B. Rear Work Stop Support Rods .................. 2
74
C. Front Work Stop ......................................... 1
72
D. Rear Work Stop Assemblies ...................... 2
E. Rear Work Stop .......................................... 1
F.
Bevel Gauge ............................................... 1
A
C
E
Figure 4. Loose inventory.
-10-
Qty
B
D
F
Fasteners (Figure 5)
G. T-Bolts M12-1.75 x 45 ................................. 3
H. Hex Bolts M12-1.75 x 30 ............................. 4
I.
Hex Bolts M10-1.5 x 20 .............................. 2
J.
Flat Washers 12mm ................................... 7
K. Flat Washers 10mm ................................... 2
L. Wing Nuts M12-1.75 .................................... 3
M. Cotter Pins M3 x 50.................................... 4
N. Clevis Pins 12 x 45mm ............................... 4
O. Clevis Pins 12 x 88mm ............................... 2
G
J
M
Figure 5. Fasteners.
Note: Some of the clevis pins and cotter pins
listed above have been provided to replace those
pre-installed on the machine in the event they
break due to wear.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Model T32957 (Mfd. Since 09/21)
Qty
H
I
K
L
N
O
Advertisement
Table of Contents
