Grizzly G0782 Owner's Manual page 86

To check/replace brake linings:
1. DISCONNECT MACHINE FROM POWER!
2. Remove end gear cover.
3. Loosen motor mount bolts (see Figure 140),
slide motor up, and remove belts.
Pulley
Cap
Screw
Figure 140. Location of pulley cap screw and
motor mount bolts.
4.
Have another person step on brake pedal to
lock pulley in place, and remove pulley cap
screw shown in Figure 140.
5. Step off brake pedal and remove pulley.
Figure 141 shows pulley removed and brake
shoes exposed.
Brake
Linings
Figure 141. Brake assembly.
-84-
Motor
Mount
Bolts
E-Clip
Springs
6.
Using your calipers, measure thickness of
brake linings.
— If linings are thicker than
earlier, then replacement is not required.
Re-assemble lathe in the opposite manner
as outlined in Steps 2–5.
—If linings are oil-soaked from over lubrica-
tion of adjacent gearing, clean and prop-
erly lubricate gears (see End Gears in
Lubrication section on Page 66), then
proceed to Step 7.
—If brakes linings are
to Step 7.
7.
Put on safety glasses and remove E-clip,
springs, and brake shoes shown in Figure
141.
8. Replace or dress drum pulley as required.
9.
Install brake shoes, springs, and E-clip.
10. Install pulley and re-assemble in opposite
manner that you disassembled it in Steps
2–5.
11. Start lathe and test brake operation.
Model G0782 (Mfd. Since 10/15)
⁄ " as described
3
16
⁄ " or thinner, proceed
3
16