Grizzly G0782 Owner's Manual page 25

To connect power cord to lathe:
1. Press Emergency Stop/RESET button on
front of headstock, then remove electrical box
cover from back.
2. Thread power cord through strain relief shown
in Figure 16.
30 31 32 33
1 0 14
Incoming Power
Strain Relief
0
7
0
L N
A2
L
A1
L
1 L1 3 L2 5 L3 21NC
Contactor
Tianshui
GSC1-1801
Figure 16. Location of hot wire terminals, ground
terminal and strain relief.
KM1
2 T1 4 T2 6 T3 22NC
3. Identify L1 and L2 terminals and ground-
11
ing plate, shown in Figure 17, then connect
Z2
U2
A2
incoming hot wires and ground wire to those
Z1
terminals.
Ground Wire
Ground
Incoming
Power Cord
Figure 17. Incoming ground and hot wires
connected.
b
Model G0782 (Mfd. Since 10/15)
E
N
N
0
0 0
L
6
A1
L
A2 A1
1 L1 3 L2 5 L3 21NC 13NO 23NO 33NO 43NC
Contactor
Tianshui
GSC1-1801
KM2
2 T1 4 T2 6 T3 22NC 14NO 24NO 34NO 44NO
12
A2
Z2 U2 Z1
11
Connected
L1 L2
Hot Wires
Connected
c
d
4.
Make sure wires have enough slack between
strain relief and terminal connections so they
are not pulled tight or stretched, then tighten
strain relief to secure cord.
Note: The strain relief must be tightened
against the outer jacket of the cord. Avoid
over-tightening the strain relief or it may
crush the cord and cause a short.
10
5.
Test strain relief to ensure it is properly
L
1
N
tightened by pulling cord from outside box
with light-to-moderate force. When strain
relief is properly tightened, cord will not move
inside cabinet.
0
6. Install a NEMA 6-15 plug on other end of
power cord per plug manufacturer's instruc-
L
N
A2 A1
tions.
13NO 23NO 33NO 43NC
7.
Re-install main electrical box cover.
Contactor
Tianshui
JZC3-40D
KA1 To avoid
Emergency Stop/RESET button pressed in
14NO 24NO 34NO 44NO
until instructed otherwise in Test Run.
3
A2
8.
Plug cord into matching power supply recep-
13
L1
N1
tacle and power source as specified in Circuit
Requirements for 220V on Page 14.
L1 N1 0 1 15 2 3 4 8 5 6
e
f
9
0
2
2
A2
Contactor
Tianshui
JZC3-40D
unexpected KA0 start-up,
5
A2
10
keep
-23-