Manual Feed - Grizzly G0782 Owner's Manual

Items Needed
Tool Post T-Wrench ........................................... 1
Steel Shims ....................................... As Needed
Cutting Tool ....................................................... 1
Tailstock Center ................................................. 1
To align cutting tool with tailstock center:
1. Mount cutting tool in tool post, then secure
post so tool faces tailstock.
2. Install center in tailstock, and position center
tip near cutting tool tip.
3.
Lock tailstock and quill in place.
4. Adjust height of cutting tool so tool tip is
aligned vertically with center tip, as illustrated
below.
(Top View)
Cutting
Tool
Cutting
Tool
Figure 54. Cutting tool aligned to the tailstock
center.
-44-
Qty
Tailstock
Center
Tailstock
Center
(Side View)

Manual Feed

The cutting tool can be manually fed into the
workpiece using the carriage, cross slide, and
compound rest handwheels shown below.
Figure 55. Manual feed controls.
Carriage Handwheel
Graduated Dial
Increments ................................... 0.01" (0.25mm)
One Full Revolution ................... 0.56" (14.22mm)
Use the carriage handwheel to move the carriage
left or right along the bed.
Cross Slide Handwheel
Graduated Dial (Inch and Metric)
Increments ....................................0.001"/0.02mm
One Full Revolution ......................... 0.2"/5.08mm
Adjust the position of the graduated scale by hold-
ing the handwheel with one hand and turning the
dial with the other. The cross slide handwheel
has a direct-read graduated dial (inch and metric),
which shows the total amount of material removed
from the diameter of the workpiece.
Compound Rest Handwheel
Graduated Dial
Increments ................................ 0.001" (0.03mm)
One Full Revolution ....................... 0.1" (2.54mm)
Use this handwheel to move the cutting tool lin-
early along the set angle of the compound rest.
Set the compound rest angle by hand-rotating
it and securing it with the two cap screws (see
Figure 51 on Page 42). The compound rest has
an indirect-read graduated dial, which shows the
actual distance the tool moves.
Model G0782 (Mfd. Since 10/15)
Compound Rest
Handwheel
Cross Slide
Handwheel
Carriage Handwheel