Appendix C: Programming Gxrm; Introduction; Software Configuration - Honeywell ISA100 Gen X User Manual

C.1 Introduction
This section gives information on the hardware and software tools that are needed as flash hex image for the
Honeywell Radio board.
Hardware requirement
The J-Link/J-Trace Debugger is needed to flash the image.
Software requirement
The SEGGER J-flash lite tool (version 6.20) needs to be downloaded from website
(https://www.segger.com/downloads/jlink/JLink_Windows_beta.exe), which is a freeware and can be used for
flashing the radio board image.
C.2 Software Configuration
This section gives information on what configuration need to be used in the tool to flash the image.
After installing the software, the following steps are to be followed to configure the device.
68

Appendix C: Programming GXRM

ISA100 Gen X Radio Module User's Guide
Honeywell
Release Independent
April 2018