Connector Details; Debug Connector Details; Figure 2: Debug Connector Pin Details - Honeywell ISA100 Gen X User Manual

There are two connectors on the Radio board:
1.
2.
3.1
The debug connector is used for programming and/or debugging the firmware on the
board.
SWS_DIO: data input/output
SWD_CLK: input clock
VCC: The operating voltage ranges from 2.7 Volts to 3.6 Volts.
Release Independent
April 2018

3 Connector Details

Debug Connector for programming or to debug the firmware on the board
Sensor-Radio interface connector

Debug Connector Details

Debug Connector Pin Details

Figure 2: Debug connector pin details

ISA100 Gen X Radio Module User's Guide
Honeywell
15