Honeywell ISA100 Gen X User Manual page 64

To comply with the IC, this unit and its antenna must not be located or operated with any other
antenna or transmitter. However, this device and its antenna may not be co-located or operated
in conjunction with any other antenna or transmitter, if installed in accordance with the procedures
of the Multi IC transmitter.
To inherit the modular approval, you must install the antennas of this transmitter at 20cm from all
people and cannot be located or operated with any other antenna or transmitter.
To the installer's equipment supplier:
the IC tag on the final system with "Contains ICs: 573W-51454941 or" contains the IC emitter
module: 573W-51454941. "
transmitter module must be installed and used in accordance with the manufacturer's instructions.
These devices comply with Part 15 of the IC rules. The transaction is subject to the following two
conditions:
(1) These devices may not cause harmful interference, and
(2) These devices must accept any interference received, including interference that may cause
undesired operation.
RF exposure statement
This equipment complies with the IC radiation exposure limits established for an uncontrolled
environment. This equipment must be installed and operated with a minimum distance of 20 cm
between the radiator and your body.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to ISED Part ICES-003 Rules.
LIST OF APPROVED ANTENNAE
To know the recommended Antennae and their respective power level settings, please refer
Table 9.
64
Release Independent
ISA100 Gen X Radio Module User's Guide
April 2018
Honeywell