Installing The Ocp Mezzanine Card; Concluding Steps - Fujitsu PRIMERGY CX2560 M4 Upgrade And Maintenance Manual

Expansion cards and OCP mezzanine cards
6.6.1.2

Installing the OCP mezzanine card

Ê Remove the OCP dummy module from the chassis.
Figure 62: Installing an OCP mezzanine card
Ê Plug the controller on the four guide pins (see circles).
Make sure that the card engages under the green hooks.
Ê If applicable, install SFP+ transceiver modules on the new OCP mezzanine
card, see section
6.6.1.3

Concluding steps

Perform the following procedures:
Ê Install the riser modules, see section
page 55.
"Installing the server node in the server enclosure" on page 67
Ê
Ê Connect all external cables.
"Controls and indicators on the server node" on page 448
Ê
160
"Installing SFP+ transceiver modules" on page
Upgrade and Maintenance Manual
"Installing the riser module" on
172.
CX2550/60/70 M4