About Battery Replacement - Honeywell CN75 User Manual

6. Tighten the screws to secure the I/O cover to the computer.

About Battery Replacement

When the battery in the computer has a low charge, replace it with a charged
battery.
You should always place the computer in Battery Swap mode before removing the
battery. Battery Swap mode places the computer in a low power state so that the
battery can be removed for a short period of time.
Note: When you remove a battery from the computer, Honeywell recommends that you
install a charged battery within one minute to maintain your network connections.
We recommend use of Honeywell Li-ion battery packs. Use of any non-Honeywell
battery may result in damage not covered by the warranty.
Ensure all components are dry prior to placing the battery in the computer.
Mating wet components may cause damage not covered by the warranty
About Battery Replacement for Non-Incedive Models
Warning: CN75 NI and CN75e NI Models
Avertissement : Modèles CN75 NI and CN75e NI
How to Replace the Battery
1. Save your files and close all open applications.
2. Press and hold the Power button, and then select Battery Swap from the menu.
8
Explosion Hazard - Batteries must only be changed or charged in an
area known to be non-hazardous. Use ONLY Honeywell CN75 NI battery
part number 1000AB02.
Risqued'explosion-Les batteries doivent uniquement être
remplacées ou rechargées dans un endroit non dangereux.
Utilisez UNIQUEMENT Honeywell CN75 NI batterie P/N
1000AB02.
75 Series Mobile Computer User Guide