Honeywell CN75 User Manual page 34

Settings App:
Heater Setting
Heater Cycle Time
Duration
Fast monitoring
interval
Slow monitoring
interval
Sample Window
Power on time
Disable temperature
Blanking
Configure the Heater in the Settings App
1. Tap All apps > Settings.
2. Tap Heater under Honeywell settings.
3. Modify the heater parameters.
4. Tap Update to apply the changes.
5. Tap OK.
Configure the Heater in the EZConfig
You can also configure the heater by modifying key values in EZConfig.
1. Tap All apps > Settings > Power Tools > EZConfig.
2. Tap Menu
24
DeviceConfig.xml:
Heater Key
Duration: DurationScanner
Scanner heater
(seconds)
Duration: DurationLCD
LCD heater
FastInterval
SlowInterval
SampleTimes
PowerOnTime
DisableT
> Generator.
Description
When the heaters are activated, the computer
cycles power between the scanner window heater
and the display window heater. You can
independently adjust the cycle time for each
heater.
Note: During pre-heating, there is a small buffer
time between heater cycles when both
heaters are turned off. The length of the
buffer is not configurable.
Set the length of time (seconds) that the scanner
heater is cycled on.
Set the length of time (seconds) that the screen
heater is cycled on.
Set sampling interval time (seconds) used once the
computer detected cold storage entry (defined by
the Heater enabled temperature.
Set sampling interval time (seconds) used once the
computer detects cold storage exit (defined by
DeltaT).
Set how many temperature samples are used to
calculate a true DeltaT event (cold storage exit).
Set the length of time (minutes) that the computer
waits after the Chill timer has expired before
activating the low power pre-heat window feature.
Set the temperature limit (°C) that triggers turning
off the heater.
Toggles turning the heater on or off during
scanning.
75 Series Mobile Computer User Guide