Connecting The Sinamics V70 Servo System; Connecting The Drive To Motor - Siemens SINUMERIK 808D ADVANCED Commissioning Manual
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Operating instructions manual (498 pages)
Table of Contents
Advertisement
4.6
Connecting the SINAMICS V70 servo system
4.6.1
Connecting the drive to motor
CAUTION
Risk of injury due to improper cable connection
When connecting cables to the drive interfaces with detachable connectors, fixing the cables directly to the connectors
which have not been fitted onto the drive may result in finger injury.
First fit the connectors onto the drive, and then fix the cables to the connectors.
•
Connecting the SINAMICS V70 FSA/FSB/FSC servo system
Note
The connection illustration below uses V70 FSA as an example, which is also applicable to V70 feed/spindle drives FSB and
FSC.
The holding brake function is available only with the feed drive.
1)
The short-circuit stick is available only with the feed drive for the use of an internal braking resistor.
2)
For the V70 spindle drive, the SIMOTICS M-1PH1 main motor is connected.
3)
126
Commissioning Manual
01/2017
Advertisement
Table of Contents
