View/Edit Schedule - Honeywell 900 User Manual

View/Edit schedule

This display lets you edit parameters of the selected schedule. Edits affect only the currently working
schedule, not the schedule in memory, unless you save the schedule .
ATTENTION
Schedule must be in READY state to edit the values on this display.
Item
View/Edit Segments Button
Schedule Information
Schedule number
Schedule Name
Schedule Description
Time Units
Jog Segment
Guaranteed Hold Limits
Revision 9
May 2014
Accesses View/Edit Schedule Segments (page 138) where you can edit
each segment.
Memory location of the schedule that is being run by the Setpoint
Programmer.
Name of the selected schedule.
Description of the schedule.
This selection assigns the time units (hours or minutes) that applies to all
segments.
Segment to which the schedule will jump to when the JOG discrete input
is pulsed.
This lets you specify the amount of deviation needed between a setpoint
and its PV for the schedule to automatically switch to GHOLD state. If any
setpoint's guarantee hold limit is exceeded, the entire schedule enters
GHOLD state (all setpoints, auxiliary setpoints, and segment events
freeze on their current value or state) until none of the limits are
exceeded, whereupon the schedule will resume RUN state.
900 Control Station User Guide
Setpoint Scheduler
View/Edit schedule
Description
137