Display Setup-Cs Edit - Honeywell S7800A Installation Manual

7800 SERIES S7800A KEYBOARD DISPLAY MODULE
CALL SERVICE
Fig. 63. CALL SERVlCE screen.
Fig. 64. Blank screen.
The blank screen is displayed for two seconds.
When done, the display will be:
DISPLAY Setup
Select: CS TEST
Fig. 65. DlSPLAY Setup/Select CS TEST screen.
Press ENTER using the two ENTER buttons at the same time.
Select
Exit
Fig. 66. Select/Exit screen.
Choose Exit.
You will be taken completely out of the Setup menu.

Display Setup-CS EDIT

CS EDIT allows customizing or personalizing a Call Service
message. Three screens of messages are available. Each
screen has two lines of text with 20 characters available. See
Table 9 for available characters. This message will be
displayed with the 7800 SERIES is in a lockout condition in
place of the normal Lockout Fault condition. Note that the Call
Service feature must be turned ON using the CS ON/OFF
selection.
To access the CS EDIT menu:
Press the left three buttons of the KDM for one second, then
release.
DISPLAY Setup will appear. If you have a personal password,
enter it to enter Setup.
DISPLAY Setup
PASSWORD: 000
Fig. 67. DlSPLAY Setup/PASSWORD screen.
65-0090-6
Press ENTER by pressing the two ENTER buttons at the same
time.
Select
Exit
Fig. 68. Select/Exit screen.
Choose Select.
DISPLAY Setup
Select: CLONE
Fig. 69. DlSPLAY Setup/Select CLONE screen.
Use the down arrow to scroll down through menu choices until
CS EDIT appears.
DISPLAY Setup
Select: CS EDIT
Fig. 70. DlSPLAY Setup/Select CS EDlT screen.
Press ENTER using the two ENTER buttons at the same time.
Select
Exit
Fig. 71. Select/Exit screen.
Choose Select.
Call Service Setup
Edit Screen: 1
Fig. 72. Call Service Setup/Edit Screen 1 screen.
Press ENTER using the two ENTER buttons at the same time.
Select
Exit
Fig. 73. Select/Exit screen.
Choose Select.
30