Table of Contents
Advertisement
If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your Adapter.
Some firewall software programs may block a DHCP request on newly installed adapters.
If you are connecting to a wireless network at a hotspot (e.g. hotel, coffee shop, airport), please contact an
employee or administrator to verify their wireless network settings.
Q: How can I set my computer to use a static IP address?
A: If you are not using a DHCP capable gateway/router, or you need to assign a static IP address, please follow
the steps below:
1.
Windows® XP: Click on Start > Control Panel > Network Connections.
Windows® 2000: From the desktop, right-click My Network Places > Properties.
2.
Right-click on the Local Area Connection which represents your network adapter and select Properties.
3.
Highlight Internet Protocol (TCP/IP) and click Properties.
4.
Click Use the following IP address and enter an IP address that is on the same subnet as your network
or the LAN IP address on your Adapter.
Example: If the Adapter's LAN IP address is 192.168.1.150, make your IP address 192.168.1.x where x is a
number between 1 and 254 but except (192.168.1.1 for example). Make sure that the number you choose
is not in use on the network. Set Default Gateway the same as the LAN IP address of your DVG-2101SP
(192.168.1.150).
5.
Click OK twice to save your settings.
Q: I get a dial tone, but when I dial any phone number I receive a busy signal.
A: The unit may not have been properly configured with the correct account information in the web-based
utility.
1.
Access the web-based utility by entering the IP address: 192.168.1.150 in the Address bar.
2.
Select the Setup tab and click the SIP Account List submenu.
3.
Enter the account information provided by your VoIP service provider, including Display Name, User
Name, Authentication Name, Password, Proxy Server (if applicable), Outbound Proxy Server (if applicable),
etc.
Q: After setting up the DVG-2101SP, I cannot access the Internet.
A: Make sure that the Ethernet cable from the PC is plugged into the LAN port of broadband modem or router
after you finish the configuration of the DVG-2101SP.
Q: Can I use my DVG-2101SP on a MGCP network?
A: No, DVG-2101SP is a SIP device and uses the SIP protocol in handling all of the telephony elements.
Copyright © 2008 D-Link Australia Pty. Ltd.
DVG-2101SP User Manual
Advertisement
Table of Contents
