Configuration Through Ivr - D-Link DVG-2101SP User Manual

Configuration through IVR

The VoIP Adapter provides a convenient IVR (Interactive Voice Response) function to help you query and
configure the basic settings of the VoIP Adapter with a phone and without turning on a PC. To access IVR
mode, plug a phone into the VoIP Adapter and then pick up the handset and press * (star) 666 # (pound).
You will hear voice instructions through the handset. Follow the system's instructions to set up or query the
VoIP Adapter's settings. To exit IVR mode, simply hang up the phone. The IVR function only supports DHCP
and Static mode configuration, other connection types need to be done via the web configuration interface. If
you pick up the handset and can not hear a tone or press *666# without IVR response, please press the Reset
button for 1-2 seconds and try again. Please refer to the Rear Panel diagram on page 5 of this manual for the
Reset button location.
Press
Setup
Press 1
DHCP
Secondary DNS
Setup Complete
Auto disconnect
Copyright © 2008 D-Link Australia Pty. Ltd.
Press
Welcome to IVR
1
Press 2
Static IP
Enter IP Try to enter
Address again
OK Error
Enter Subnet Try to enter
Mask again
OK Error
Enter Default Try to enter
Gateway again
OK Error
Enter Primary Try to enter
DNS again
OK Error
Enter Try to enter
again
OK Error
*666#
Press 1
WAN
Registration
Successful
Return to
previous
menu
Indication
Press *666# to enter IVR mode
Press # key to skip this step or end the input
Press * key to return to previous level or
represent "." (dot)
Example:
To enter a set IP address of 192.168.1.150
press 192*168*1*150#.
DVG-2101SP User Manual
Press 2
Query
Press 2
VoIP
Registration Registration
Successful
Auto return Return to
to Welcome previous
menu
Fail
menu