Honda 08E91-E22-100B Installation Instructions Manual page 11

Installing the Control Unit Bracket
33. Locate small square hole next to small round hole in
the dashboard support bracket. Under the dash,
attach the control unit bracket to the vehicle bracket
near the lower A-pillar using a flange nut. If the
vehicle is equipped with a moonroof, be careful not
to pull on the drain tube.
VEHICLE
BRACKET
VEHICLE
BRACKET
CONTROL UNIT
BRACKET
© 2009 American Honda Motor Co., Inc. – All Rights Reserved.
FRONT
FLANGE
NUT
872626AT
AII 42460 (0908)
Routing the Engine Starter Harness
34. Using isopropyl alcohol on a shop towel, clean the
areas where the fuse labels will attach. Attach the 3A
fuse labels to the engine starter harness fuse case,
and the 40A fuse labels to the fuse block.
LAYOUT OF RELAYS
WHEN VIEWED FROM FRONT
5-PIN
RELAY
(green)
CLIP
FUSE
BLOCK
Clean.
4-PIN RELAY
(black)
35. Install the four relays to the engine starter harness
relay blocks. Be careful to install the relays properly,
or a malfunction will result.
4-PIN
RELAY
(black)
RELAY
BLOCK
40A FUSE
FUSE
LABEL
CASE
3A
FUSE
LABEL
Clean.
872627AT
11 of 21