Honda 08E91-E22-100B Installation Instructions Manual page 11

Installing the Control Unit Bracket
33. Locate the small square hole next to the small
round hole in the dashboard support bracket.
Under the dash, attach the control unit bracket to
the vehicle bracket near the front lower pillar using
a flange nut. If the vehicle is equipped with a
moonroof, be careful not to pull on the drain tube.
VEHICLE
BRACKET
VEHICLE
BRACKET
CONTROL UNIT
BRACKET
© 2007 American Honda Motor Co., Inc. - All Rights Reserved.
Routing the Engine Starter Harness
34. Attach the 3A fuse labels to the engine starter
FRONT
FLANGE
NUT
35. Install the four relays to the engine starter
6D01123T
AII 38215 (0710)
harness fuse case, and the 40A fuse labels to the
fuse block.
LAYOUT OF RELAYS
WHEN VIEWED FROM FRONT
5-PIN
RELAY
(green)
CLIP
FUSE
BLOCK
4-PIN RELAY
(black)
harness relay blocks. Be careful to install the
relays properly, or a malfunction will result.
4-PIN
RELAY
(black)
RELAY
BLOCK
FUSE
40A FUSE
CASE
LABEL
3A
FUSE
LABEL
6D01031T
11 of 21