Honda 08E91-E22-100B Installation Instructions Manual page 10

31. Secure the antenna cable to the vehicle harness
with a wire tie. Secure the wire tie between the
vehicle harness branching points.
VEHICLE
HARNESS
BRANCHING
POINT
10 of 21
WIRE TIE
ANTENNA
CABLE
6D01281T
AII 38215 (0710)
Setting the Control Unit
32. Get the control unit. Using a small flat-tip
screwdriver, adjust the switches on the control
unit to the locations shown. Using a isopropyl
alcohol on a shop towel, clean the area where the
protective tape will attach. Attach the protective
tape to the control unit over the switches.
NOTE:
• If the switch setting is not correct, the engine
starter will not operate correctly.
• If setting the switches when the control unit is
installed in the vehicle, touch a metal part of
the screwdriver to a metal part of the vehicle
to discharge any static electricity.
CONTROL
UNIT
PROTECTIVE
TAPE
ADHESIVE
BACKING
SW : 1 RR Junction Unit
SW : 2 Trunk or Tailgate
SW : 3 Smart Entry
SW : 4 Horn or Buzzer Answer Back
SW : 5 Trunk Main SW
SW : 6 Reserve
© 2007 American Honda Motor Co., Inc. - All Rights Reserved.
SWITCH
Clean with
isopropyl alcohol.
6D01022T