NETGEAR FVG318 Reference Manual page 98

ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual
5. In the End Point Information section, enter the Remote WANs IP Address or Internet Name
and the Local WAN's IP Address or Internet Name. Both local and remote ends must be
defined as either IP addresses or Internet Names (FQDNs).
Note: The Local IP Address field can be left as the default address unless you are
using a different IP Address or FQDN.
Figure 5-23
6. In the Security Connection Remote Accessibility section, enter the remote LAN IP address
and Subnet Mask at the target endpoint that can use this tunnel.
Note: The IP Address range on the remote LAN must be different from the IP
Address range on the local LAN.
You can view the VPNC recommended authentication and encryption settings used by the
VPN Wizard by clicking the VPN Wizard Default Values link.
5-20
v1.0, September 2007
Select the radio button:
A remote VPN Gateway
Enter the new Connection
Name: (GtoG in this example)
Enter the pre-shared key:
(12345678 in this example)
Enter the WAN IP address of
the remote VPN gateway:
(22.23.24.25 in this example)
Enter the LAN IP settings of the
remote VPN gateway. For
example:
• IP Address (192.168.3.1)
• (255.255.255.0)
Subnet Mask
Basic Virtual Private Networking