Setting Up A Client-To-Gateway Vpn Configuration; Step 1: Configuring The Client-To-Gateway Vpn Tunnel On The Fvg318 - NETGEAR FVG318 Reference Manual

Setting Up a Client-to-Gateway VPN Configuration

Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway (see
• "Step 1: Configuring the Client-to-Gateway VPN Tunnel on the FVG318" on page 5-5
the VPN Wizard to configure the VPN tunnel between the remote PC and network gateway.
• "Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC" on page 5-7
configures the NETGEAR ProSafe VPN Client endpoint.
FVG318
Figure 5-3
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
FVG318
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
not covered by these VPNC-recommended parameters, refer to
"Advanced Virtual Private
Follow this procedure to configure a client-to-gateway VPN tunnel using the VPN Wizard.
1. Log in to the FVG318 at its LAN address of http://192.168.0.1 with its default user name of
admin and password of password.
Basic Virtual Private Networking
ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual
Figure 5-3) involves the following two steps:
Table 5-1 on page
Networking" to set up the VPN tunnel.
v1.0, September 2007
5-4. If you have special requirements
Chapter 6,
uses
5-5