NETGEAR FVG318 Reference Manual page 175

2. Test 2: Ping Remote WAN IP Address (if Test 1 fails): To test connectivity between the
Gateway A and Gateway B WAN ports, follow these steps:
a. From a Windows Client PC, click the Start button on the task bar and then click Run.
b. Type ping -t 14.151.6.17, and then click OK.
c. This causes a ping to be sent to the WAN interface of Gateway A. Within two minutes, the
ping response should change from timed out to reply. You may have to run this test several
times before you get the reply message back from the target FVS318v3.
d. At this point the gateway-to-gateway connection is verified.
3. Test 3: View VPN Tunnel Status: To view the FVG318 event log and status of Security
Associations, go to the FVG318 main menu VPN section and click the VPN Status link. For
the For the VPN Client, click VPN Status on the VPN Status/Log screen.
a. Open the popup menu by right-clicking on the system tray icon.
b. Select Connection Monitor.
VPN Configuration of NETGEAR FVG318
ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual
v1.0, September 2007
C-19