Setting Up A Gateway-To-Gateway Vpn Configuration - NETGEAR FVG318 Reference Manual

Setting Up a Gateway-to-Gateway VPN Configuration

Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
not covered by these VPNC-recommended parameters, refer to
"Advanced Virtual Private
FVG318 VPN Firewall
Figure 5-22
The following procedure will show how to set the LAN IPs on each FVG318 to different subnets
and configure each properly for the Internet.
• The LAN IP address ranges of each VPN endpoint must be different. The connection will fail
if both are using the NETGEAR default address range of 192.168.0.x.
• In this example, LAN A uses 192.168.0.1 and LAN B uses 192.168.3.1.
To configure a gateway-to-gateway VPN tunnel using the VPN Wizard.
1. Log in to the FVG318 on LAN A at its default LAN address of http://192.168.0.1 with its
default user name of
2. Select VPN > VPN Wizard from the main menu. The VPN Wizard screen will display.
3. Select the Gateway radio box in the About VPN Wizard section.
4. In the Connection Name and Remote IP Type section, enter the Connection Name and the pre-
shared key.
Basic Virtual Private Networking
ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual
Table 5-1 on page
Networking" to set up the VPN tunnel.
and password of
admin
v1.0, September 2007
5-4. If you have special requirements
FVG318 VPN Firewall
.
password
Chapter 6,
5-19