NETGEAR FVG318 Reference Manual page 30

ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual
4. Select Network Configuration. The WAN ISP Settings screen will display. Click Auto Detect
at the bottom of the WAN ISP Settings screen. The router will automatically attempt to detect
your connection type. A message will display indicating if the service connection was
detected.
Figure 2-8
If you know your ISP connection type or if want to bypass the auto configuration, you can
manually configure the router settings on the WAN ISP screen. See the
Configuring your Internet Connection" on page 2-7
5. Click Test to verify that the Internet connection is active.
Note: You might want to enable remote management at this time so that you can log
in remotely in the future to manage the gateway. See
Management Access" on page 8-8
enable is cleared with a factory default reset.
2-6
to connect your router manually.
for more information. Remote management
v1.0, September 2007
"Manually
"Enabling Remote
Connecting the Firewall to the Internet