Default Settings And Technical Specifications; Default Settings - NETGEAR FVG318 Reference Manual

Default Settings and Technical Specifications

Default Settings

You can use the reset button located on the front of your device to reset all settings to their factory
defaults. This is called a hard reset.
• To perform a hard reset, push and hold the reset button for approximately 5 seconds (until the
TEST LED blinks rapidly). Your device will return to the factory configuration settings shown
in below. (The Factory Default Restore button on the rear panel is shown in the illustration
"The FVG318 Rear Panel" on page
• Pressing the reset button for a shorter period of time will simply cause your device to reboot.
After you install the VPN firewall, use the procedures below to customize any of the settings to
better meet your networking needs.
Feature
Router Login
User Login URL
User Name (case sensitive)
Login Password (case sensitive)
Internet Connection
WAN MAC Address
WAN MTU Size
Port Speed
Local Network (LAN)
Lan IP
Subnet Mask
RIP Direction
RIP Version
RIP Authentication
DHCP Server
Default Settings and Technical Specifications
1-6.)
Default Behavior
http://192.168.0.1
admin
password
Use Default address
1500
AutoSense
192.168.0.1
255.255.255.0
None
Disabled
None
Enabled
v1.0, September 2007
Appendix A
A-1