NETGEAR FVG318 Reference Manual page 171

b. Add a new connection using the Edit/Add/Connection menu and rename it Scenario_1.
(Scenario_1 is used in this example to reflect the fact that the connection uses the Pre-
Shared Key security scheme and encryption parameters proposed by the VPN
Consortium, but you may want to choose a name for your connection that is meaningful to
your specific installation. The name you choose does not have to match the name used at
the gateway end of the VPN tunnel.)
Figure C-7
c. Program the Scenario_1 connection screen as follows (see
• Connection Security: Secure
• Remote Party Identity and Addressing: Select IP Subnet from the ID Type menu and
then enter 10.5.6.1 for Subnet, 255.255.255.0 for Mask, and leave All for Protocol.
(The Subnet and Mask parameters entered here must match the Start IP address and
Subnet Mask parameters of the Local IP Traffic Selector on the VPN Auto policy
screen shown in
• Enable Connect Using Secure Gateway Tunnel; select Domain Name for ID_Type;
enter fvs_local for Domain Name; and enter 14.15.16.17 for Gateway IP Address.
(Domain Name must match the Local Identity Data parameter of the IKE Policy
Configuration screen shown in
Address must match the WAN IP address of the gateway router shown in
• Expand the Scenario_1 screen hierarchy by clicking the + sign in front of Scenario_1.
Then expand the rest of the screen hierarchies by clicking the rest of the + signs.
VPN Configuration of NETGEAR FVG318
ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual
Figure C-9 for the gateway router.)
Figure C-8
v1.0, September 2007
Figure C-8):
for the gateway router. Also, Gateway IP
Figure C-8.)
C-15