NETGEAR FVG318 Reference Manual page 126

ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual
This screen shows the following parameters:
Table 7-1. FVG318 Status fields
Field
System Name
Firmware Version
Wireless Configuration
SSID:
Mode
Security Settings
Region
Channel
AP MAC Address
WAN Port
WAN State
NAT
DHCP
Connection State
IP Address
IP Subnet Mask
Gateway
Primary DNS
Secondary DNS
DHCP
MAC Address
LAN Port
MAC Address
7-2
Description
The System Name assigned to the firewall.
The firewall firmware version.
The wireless settings of the router
The name of your wireless network. The default is NETGEAR.
Shows what security has been associated with the wireless configuration. The
default is none
Shows the region is which the wireless gateway is operating
Indicates the operating channel of the wireless radio.
The MAC address of the wireless access point.
These parameters apply to the Internet (WAN) port of the firewall.
Indicates if the WAN port is up or down.
Indicates if the router is in NAT mode (enabled) or in routing mode (disabled).
The protocol on the WAN port used to obtain the WAN IP address. This field
can show DHCP Client, Fixed IP, PPPoE, BPA or PPTP. For example, if set to
Client, the firewall is configured to obtain an IP address dynamically from the
ISP.
Indicates if the WAN port is connected or not.
The IP address used by the Internet (WAN) port of the firewall. If no address is
shown, the firewall cannot connect to the Internet.
The IP Subnet Mask being used by the Internet (WAN) port of the firewall.
Gateway address of the WAN port.
DNS server IP address of the WAN port.
Secondary DNS server IP address of the WAN port (if not assigned, it will be
the same as the primary DNS server).
The protocol on the WAN port used to obtain the WAN IP address. This field
can show DHCP Client, Fixed IP, PPPoE, BPA or PPTP. For example, if set to
Client, the firewall is configured to obtain an IP address dynamically from the
ISP.
The MAC address used by the Internet (WAN) port of the firewall.
These parameters apply to the Local (WAN) port of the firewall.
The MAC address used by the LAN port of the firewall.
v1.0, September 2007
Maintenance