Cisco WVC210 Reference Manual page 60

Network Camera Configuration File Spec V1.03
Configuration File Format
Cisco Small Business Network Camera Exported CGI Commands
Parameter
wep_mode
wep_index
wep_ascii
wep_kep1
wep_kep2
wep_kep3
wep_kep4
wpa_ascii
connection_mode
Value and Description
Set WEP key mode. The choices are:
•
1 — 64-bit (10HEX)
•
2 — 128-bit (26 HEX)
•
3 — 64-bit (5 ASCII)
•
4 — 128-bit (13 ASCII)
Set the active WEP key number. The choices are:
•
1 — WEP key 1
•
2 — WEP key 2
•
3 — WEP key 3
•
4 — WEP key 4
Set the WEP passphrase. Can be 1-32 characters.
Set WEP key 1.
Set WEP key 2.
Set WEP key 3.
Set WEP key 4.
Set the WPA passphrase key. Can be from 8 to 63
characters.
Set the wireless type during device boot up. The
connection mode is reset to the default value after it is
used. The default is 0.
•
0 — If a connection is available over the Ethernet
interface, the device uses Ethernet; otherwise, it uses
wireless.
•
1 — The device use wireless whether a connection is
available over the Ethernet or not.
•
2 — The device enters WPS PBC mode over wireless
whether a connection is available over the Ethernet or not.
•
3 — The device enters WPS PIN code mode over
wireless whether a connection is available over the
Ethernet or not.
A
55