Toshiba Strata CTX Programming Manual page 183

F
IELD
05 Station Terminal
Authentication Mode
06 Station MAC Address
07 Voice Packet
Configuration Table Index
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
D
ESCRIPTION
Apply this parameter if you want to reserve a PDN for the IP Telephone
connected at the present time. When 'apply' is set, terminal authentication
by MAC address of IPT is valid. So if other IPT which has the same PDN is
connected the network, CTX rejects the registration of this IPT because the
MAC address of IPT is different. When 'not apply' is set, you can move the
PDN from a IPT to another IPT and another IPT can be connected to the
CTX. When 'don't care' is set, terminal authentication for this telephone is
determined by Program 150-02.
The Terminal Authentication setting 'Apply or Not Apply' in this program
overrides the Terminal Authentication any setting in Program 150-02. Refer
to Table 8-1.
Possible values: Apply, NotApply or DontCare (default)
Station Media Access Control (MAC) Address. This address is hard coded
uniquely in each IPT. The MAC will only display if the IPT is connected to
the BIPU-M1A and is operating properly.
Possible values: Up to 12 digits
Select the Voice Packet configuration table that should be assigned to this
IPT. The voice table is configured in Program 152. This setting is used with
Audio Codec type. When the G711 Audio Codec is selected in 08 Audio
Codec below, the interval of packet transmission has to be set 20ms or
40ms. The interval is set in Program 152-01. Example, If you want to set
G711 interval to be 20ms and Prg 152-01 Voice Packet Interval table No.1
is 20ms, you set 08 Audio Codec as G711 and 07 Voice Packet Table to be
Table No.1.
Possible values: 1~128 (CTX100 and CTX670 Basic)
1~256 (CTX670 Exp.)
IP Telephone Programming
250 Station IP Data Assignment
8-7