Bosch DCN Next Generation Operation Manual page 235

Conference System
Value
On*
Standby
Subscription
Off
Table 8.6: System mode values. (* = default)
Fault Status
Use the 5 Fault Status menu item to see the condition messages of the central control unit.
Bad signal and battery Low will be reported from Slave CCU to Master CCU.
Messages
Restart CCU
No Network
No Master CCU
CCU Missing
Download CCU
Download CCUs
Download WAP
Bad Signal
Low Battery
No Fault
Table 8.7: Messages (high or low importance)
Monitoring
Use the 6 Monitoring menu item to open the Monitoring sub-menu.
Menu item
6 Monitoring
Table 8.8: Monitoring sub-menu (* = default)
Bosch Security Systems B.V.
Description
Switches on the power of the ACN trunks and the wireless network.
Puts the wireless units into standby mode and switches off the power
of the ACN trunks.
Allows the subscription of wireless units during installation.
Puts the wireless units off mode and switches off the power of the
ACN trunks.
Description
The firmware in the CCU stopped unexpectedly and the CCU needs to
be restarted manually
Optical network is disconnected.
The CCU is in multi-slave mode and the Ethernet connection with the
master CCU is lost.
If the master CCU detects that the Ethernet connection with a slave
CCU is lost.
CCU software does not start up properly or an internal version conflict
has occurred.
If the master CCU detects incompatible software versions between
master and one or more slave CCUs.
The WAP contains an incompatible SW version.
A bad signal for a wireless unit is notified.
A low battery for a wireless unit is notified.
The CCU operates correctly.
Parameter Value
Signal: Volume level:
Floor* -31 to 0 dB (-16 dB*)
Input 1 -31 to 0 dB (-16 dB*)
Input 2 -31 to 0 dB (-16 dB*)
Output 1 -31 to 0 dB (-16 dB*)
Output 2 -31 to 0 dB (-16 dB*)
Operation Manual
Operation | en
Description
The signal that is available on
the headphones socket of the
central control unit and its
volume level.
2013.11 | V2.0 | DCN-NG_OM_V4.x
235