Bosch DCN Next Generation Operation Manual page 219

Conference System
7.14 DCN-FCS Channel Selector
The component side of the PCB of the channel selector contains solder spots. With these
solder spots, you can configure the channel selector.
Figure 7.25: Solder spots
Solder spot
X11
X12
X13
Table 7.35: Solder spots
Auto standby function
Use the X11 solder spot to enable or disable the auto standby function of the channel
selector.
Solder spot
Not Soldered*
Soldered
Table 7.36: Solder spot X11 (* = default)
Notice!
When you use the channel selector to record audio, you must close the X11 solder spot.
Bosch Security Systems B.V.
X11
X12
X13
Function
Auto-standby function.
Volume increment/decrement function.
Channel/volume restore function.
Function
The auto standby function is enabled. When the headphones are
disconnected, the channel selector is disabled.
The auto standby function is disabled. When the headphones are
disconnected, the channel selector remains enabled.
Operation Manual
Configuration | en 219
2013.11 | V2.0 | DCN-NG_OM_V4.x