Bosch DCN Next Generation Operation Manual page 163

Conference System
Figure 6.70: Stripping the cable
Crimp the bush
Do as follows:
1.
Notice!
The crimping tool (tool 3) makes the circular shape of the cable cross-section and the
crimping bush at the end of the outer sheath into a hexagonal shape. Before you crimp the
bush, make sure that both plastic optical fibers are parallel to a flat side of the hexagonal
cross-section.
Figure 6.71: Cross-section transformation
2.
Bosch Security Systems B.V.
Put the cable end through crimping bush to the end of the outer sheath.
R B
A
B R
A
Use the crimping tool (tool 3) to attach the crimping bush to the outer sheath. The
crimping bush stops the cable from rotating in the connector.
B
R
B
R = Red
B = Brown
Operation Manual
Connection | en 163
2013.11 | V2.0 | DCN-NG_OM_V4.x