Bosch DCN Next Generation Operation Manual page 206

206 en | Configuration
8Fb WAP mode
Carrier: 0 High
8Fb WAP mode
Carrier: 2 High
Figure 7.13: Carriers for adjacent systems
You can change the carrier after you did the initialization of the system (refer to Initialization,
page 178).
Notice!
When you change the carrier during a discussion or conference, you can cause a short audio
disruption.
Power value
The wireless access point has a typical maximum coverage area of 30 m by 30 m. To
determine the exact coverage area the coverage test kit can be used. The maximum coverage
area of the wireless access point is dependent upon its power. Set the power of the wireless
access point with the 4Kd WAP menu item.
Value
High
Medium
Low
Off
Table 7.23: Power values
You can change the power value after you did the initialization of the system (refer to
Initialization, page 178). When you decrease the power value, some wireless devices can show
that they cannot find the wireless network.
2013.11 | V2.0 | DCN-NG_OM_V4.x
8Fb WAP mode
Carrier: 1 High
Typical Coverage Area (m)
30 x 30
20 x 20
10 x 10
0
Operation Manual
Conference System
Bosch Security Systems B.V.