Bosch DCN Next Generation Operation Manual page 201

Conference System
7.8 CobraNet Configuration
CobraNet Discovery can be used to change configuration settings in a CobraNet device.
One CobraNet device at a time may be configured. Select the device to be configured in the
main CobraNet Discovery window. Then either right click, and select Configure... or select
Configure... from the Tools menu. You may also double click on the device to invoke the
Configuration dialog.
Figure 7.8: CobraNet device configuration window
This dialog shows each transmitter and receiver in the device along with its bundle number
assignment and transmission or reception status. A non zero value in the Status column
indicates that the transmitter or receiver is receiving or sending a bundle. In addition to
transmitter and receiver information, the dialog will also display the IP address currently
assigned to the device as well as its conductor status: the Conductor check box will be
checked if the device is the conductor for the network.
Bundles
The CobraNet network uses bundles for the transport of audio signals. The CobraNet interface
can:
–
Receiver bundles
Each receiver bundle can have 8 bundle channels. To the bundle channels of a receiver
bundle, you can connect the audio inputs of the CobraNet interface. Thus, the audio inputs
take audio signals from the CobraNet network and send them to the optical network.
Do as follows to configure a receiver bundle of the CobraNet interface:
1.
2.
3.
Bosch Security Systems B.V.
Receive 4 bundles from the CobraNet network (Rx). Send 4 bundles to the CobraNet
network (Tx).
Highlight the line containing the receiver information and then press the Configure button.
Or, double click the line containing the receiver information and then press the Configure
button.
In the Bundle Number field of the receiver bundle, enter the number of the bundle that the
receiver bundle must take from the CobraNet network.
Enter the submap number to which the bundle must connect. The CobraNet interface
receiver channels 1..4 correspond to SubMap numbers 33..36.
Operation Manual
Configuration | en 201
2013.11 | V2.0 | DCN-NG_OM_V4.x