HP 16600A Series User Manual page 195

Chapter 8: Using the Emulator with a Debugger
Using the Software Development Systems debugger
Getting started
1 Check that your emulation module is programmed with firmware
for a CPU32 processor:
Go to the system window of the logic analyzer interface and verify that
the Emulation Module icon is described as a "Motorola CPU16/32 BDM
Emulator". If it is not, follow the instructions on page 144 to update
the firmware.
2 Connect to the emulation module:
a Start SingleStep running on your PC or workstation.
b When the small Debug dialog box appears in the middle of the
screen, click the Connection tab and then enter the IP
address of the HP logic analysis system which contains the
emulation module.
If the Debug dialog box is not visible, select
Note: SingleStep is hard-coded to connect to the emulation module at port
6470 of the logic analysis system frame. See page page 180 for more
information on port numbers.
3 Configure the emulation module with the processor clock speed.
In the Debug dialog box, click the Connection tab and then enter a
Processor Clock speed which is less than or equal to the speed at which
the processor will run out of reset.
The emulation module must know the target clock speed before it can
communicate with the target. This value depends on the oscillator or
crystal used on your target system and the multipliers applicable at
reset. The communications speed can be changed (see "Download
performance" on page 201) but will be reset to this value each time
SingleStep resets the processor.
4 Initialize the target system.
The target system must have various registers and memory locations
initialized before it can access RAM and before SingleStep can
download an application. Normally, code in the target's boot ROM
194
File©Debug
.
Solutions for CPU32