HP 16600A Series User Manual page 143

4 Plug one end of the 10-pin cable into the target interface module.
5 Plug the other end of the 10-pin cable into the target system.
CAUTION:
6 Turn on the power to the logic analysis system, then turn on the
See Also
Chapter 6: Connecting and Configuring the Emulation Module
Connecting the Emulation Module to the Target System
Orient the red wire toward pin 1 of the connector. Pins 1 and 2 of the
cable should be the ones which are not connected. Connect pin 3 of the
cable to pin 1 of the target connector.
Be careful to orient the connector as shown below. If the connector is rotated,
your target system or the emulator may be damaged.
power to the target system.
"Designing a Target System for the Emulation Module" on page 130.
142 Solutions for CPU32