1 Telnet to the IP address.
2 At the prompt, type:
3 To exit from this telnet session, type <CTRL>D at the prompt.
See Also
To verify communication with the emulator
For example, on a UNIX system, enter "telnet <IP_address> 6472".
This connection will give you access to the emulator's built-in terminal
interface. You should see a prompt, such as "M>".
ver
You should then see information about the emulator and firmware
version.
The online help or manual for your logic analysis system, for
information on physically connecting the system to the LAN and
configuring LAN parameters.
If you have problems verifying LAN communication, see page 275.
Solutions for CPU32
Chapter 8: Using the Emulator with a Debugger
Setting up Debugger Software
181