CAUTION:
See Also
Setting up Debugger Software
The instructions in this manual assume that your PC or workstation is
already connected to the LAN, and that you have already installed the
debugger software according to the debugger vendor's documentation.
To use your debugger with the emulator, follow these general steps:
• Connect the emulator to your target system (see page 139).
• Connect the emulator or logic analysis system to the LAN (page 178).
• Export the logic analysis system's display to your PC or workstation
(page 182).
• Configure the emulator (page 146).
• Begin using your debugger.
If you use the Emulation Control Interface to configure the emulator,
remember to end the Emulation Control Interface session before you
start the debugger.
Do not use the Emulation Control Interface at the same time as a debugger.
The Emulation Control Interface and debuggers do not keep track of
commands issued by other tools. If you use both at the same time, the tools
may display incorrect information about the state of the processor, possibly
resulting in lost data.
Refer to the documentation for your debugger for more information on
connecting the debugger to the emulator.
Solutions for CPU32
Chapter 8: Using the Emulator with a Debugger
Setting up Debugger Software
177