Table of Contents
Advertisement
20
Software Setting
Subnet Mask
To reset these values, press and hold the Reset button for five seconds.
USB Switch
The USB ports on the CMM can function in either 2.0 or 1.1 mode (the
default is 1.1). A switch located on the PCB at the back of the CMM
module is used to change the USB mode (see Figure 2-10).
To access the switch, you need to remove the CMM from the enclosure.
Pull the CMM out and locate the switch near the large gray connector.
The settings are silk screened on the PCB. After setting the switch,
insert the CMM module back into its bay.
Module Installation
Make sure the cover to the module has been installed before
proceeding.
Installing the Module:
1.
Remove the dummy cover from the bay you want to place the
module in.
2.
Place the module's release handle in the open position.
3.
Slide the module into the module bay until it stops.
4.
Push the release handle to the closed position.
5.
After the module has been installed and the handle locked, it will
turn on and a POST test will run to verify it is working properly.
Default
Reset to 255.255.255.0
Figure 2-10. USB Switch on Rear of CMM
2 Chassis Enclosure
Advertisement
Chapters
Table of Contents
