Table of Contents
Advertisement
263
Installing/Removing a Switch
Module
Installing a Switch Module
1.
Make sure the cover to the module has been installed before
proceeding. Follow the anti-static precautions described in
"Electrostatic discharge precautions" on page vii.
2.
Remove the dummy cover from the bay you want to place the
module in.
3.
Place the module's release handle in the open position.
4.
Slide the module into the module bay until it stops (see the
following table).
1/10Gb Ethernet
Switch Modules
1G PORT IN
10G PORT
Stack ID
3
2
1
4
3
2
1
CX4
CX4
1G PORT IN
5.
Push the release handle to the closed position.
Figure 4-163. Switch Module Location
RS232
SFP
RESET
Advertisement
Chapters
Table of Contents
