Acer AB460 F1 User Manual page 354

334
Stack Configuration
Clicking the S
TACK
which configures the stacking feature. The parameters for this page
are shown in the following table.
Parameter
Switch ID
Ports
Priority
Figure 4-213. Stack Configuration
S tab brings up the S
ETTINGS
Description
This parameter defines a switch identifier number for
this switch. This identifier should be unique in the
stack, since the number is used in referring all physical
interfaces available in this switch.
So for example, if this parameter is choosen as
physical interfaces will be referred as
so on.
For non-stacking, stand-alone cases this switch ID is
zero
considered as
This parameter represents the number of stacking
ports. You can choose the number based upon your
preferred stacking configuration and available CX4
ports. It is recommended that you use two CX4 ports as
stacking ports to get redundancy.
This parameter chooses the priority for this switch in
the Stacking Master selection. It could be configured as
Preferred Master
4 Networking Switch Modules
C
TACK ONFIGURATION
.
Backup Master
, or
page,
2
, the
Gi2/1 Gi2/1
, and
Preferred Slave
.