Connection And Controls On The Control Cabinet - Bosch WS502 Instruction Manual

26/64 Bosch Rexroth AG
About this Product
1. VAC31 connection module
2. RESET illuminated pushbutton
3. Ethernet interface
4. Main switch

5.6.1 Connection and controls on the control cabinet

On both sides of the WS502 training system control cabinet there are various
connection elements and controls.
Connection elements and controls on the right-hand side
1
2
3
4
Abb. 12: Connection and controls on the control cabinet
Connector box VAC31 for hand control
1
VH2110
Illuminated pushbutton RESET (blue)
2
Ethernet connection
3
Use the VAC31 connection module to connect the hand control VH2110 to the
controller via cable.
The RESET (blue) illuminated pushbutton is used to execute various
acknowledgements on the system. Whenever a state has to be acknowledged by
the user the illuminated RESET pushbutton flashes; otherwise it is off.
The connection to the control cabinet-internal XM2200 control or the robot can be
made through the Ethernet interface (RJ45).
The main switch is used to switch the power supply for the entire WS502 training
system on or off.
Individual elements in the control cabinet are energized even when the main
switch is switched off!
The power supply to the connected extension modules are not switched off
through the main switch.
Robotics Trainings System WS502
5
Main switch
4
Type plate
5