Setting Of The Crosspoint Table - Sony HDS-7150 Installation Manual

HDS-7150
9-3. Set-up

9-3-3. Setting of the Crosspoint Table

The crosspoint table of the control panel BKDS-7017 for this setup is set to "1" as factory setting. The
BKDS-7017 does not require the setting of the crosspoint table because the crosspoint table is used
normally without changing. Proceed to "9-3-4. Assigning of the Crosspoint".
When another switcher control panel such as BKDS-2010 is connected to the HDS-7150 and it requires to
assign the different crosspoint with the BKDS-7017, perform this setting.
(1) In the set-up menu screen, press the keys on the display panel in the following sequence.
[1] (SYSTEM), [F4] (SYSTEM CONFIG), [F10] (MLT XPT ASSIGN)
The function key indications change as follows.
PORT
SELECT
F1
(2) Press the [F1] (PORT SELECT) key to move the cursor to the 9-pin port (PANEL 2, etc.) that is
connected to the switcher control panel to select the crosspoint table.
(3) Press the [F4] (TABLE SELECT) key to move the cursor to desired crosspoint table number.
(4) Press the [F3] (SELECT) key.
9-10
TABLE
SELECT SELECT
F2 F3 F4 F5
XPT ASSIGN SETUP
1 2 3 4
F8 F9 F10
F6 F7
5
HDS-7150/7100